不知道大家在對電動叉車充電時有沒有遇到這種情況，電動叉車的電瓶會無緣無故的發熱，該如何處理呢？下面重慶電動叉車小編就來給大家講一下電動叉車的電瓶發熱處理方法

1、發現電動叉車電瓶異常高溫、發熱、冒煙等情況，需要馬(ma)上停止叉車運行，停止充電，需要進一步檢測電池及車輛、充電機等各種可影響電池高溫的原因，如果叉車電池持續的大電流放電，造成蓄電池溫度高，電解液迅速揮發，板會燒毀，活性物質脫落，當然板老化，使蓄電池的內阻增大，內阻在使用過程中產生大量的熱量，也造成蓄電池高溫，這種情況下存在潛在的隱患，要及時 更換蓄電池；還有就是叉車線路板問題，大家都知道，叉車依靠蓄電池作為驅動力，線路一旦出現故障，那么電池電流也會增大，造成高溫也存在可能，叉車 司機要經常用手感受一下叉車電池的溫度，叉車的鉛酸蓄電池在充電或放電時，自身的溫度不要超過35攝氏度。低溫會使叉車電瓶的容量減小，在50 F°環境下，蓄電池要損失大約40的容量。因此，電池室的溫度需要集中控制。高與低的溫度差應小于25-35 °之間。

2、叉車蓄電池在后期不使用的時候需要保存注意，避免急用叉車時候，電能不足，這種管式鉛酸蓄電池，存在自放電，對 環境要求比較嚴格，保管時請注意溫度不要超過-20℃～+40℃范圍。需要使蓄電池在充電狀態下進行保管。由于在運輸途中或保存期內因自放電會損失一 部分容量，使用時請補充電。如果長期擱置不用時候，為彌補保管期間的自放電，請進行補充電。每月補充電能一次，在超過40C條件下保管時，對電池壽命 有很壞影響，請避免！

3、叉車電瓶電量不夠，這種情況通常是因為不正確的充放電導致的電池擁堵導致，這個時候我們應該停止使用叉車，并且把電池的兩接在放電樁上把電放掉，然后插上電源把電充滿。

4、叉車鉛電瓶無法充電，顯示電池為0，這個時候要小心了，先把電源拿出來，放在露天1個小時左右釋放掉原來電池附帶的靜電，然后充電試試，假如不行，需要要專業的工具把電池盒打開，拆除掉明顯有鼓包的電池，然后按順序把剩下的蓄電池接好。這樣我們會發現電池又可以充電和使用了。